Installing port powered swipe reader – MagTek 99875125 User Manual

Page 91

Advertising
background image

Appendix A. Installation and Setup

Installing Port Powered Swipe Reader:

Set “PPSR” under the “INSTALL” section. If you have selected to install the Port powered swipe reader
driver then change the device settings under the “PPSR” section.

Change the value of PortName, UsePort, baud, datasize, stopbits, and parity.

Example:
[PPSR]
DEVICE= "Port-powered swipe reader"
FriendlyName="Port-powered swipe reader"
PortName=COM8:
UsePort=COM1:
baud=9600
datasize=7
stopbits=1
parity=EVEN

83

Advertising
See also other documents in the category MagTek Equipment: