Install the power feed canopy, 1a 1c 1a 2a, 1a 2b – LBL Lighting LED Illum MO 4" Round Dual Feed Canopy User Manual
Page 2
2
Feed the coaxial cable up and into the canopy post.
Slide the metal sleeve up into the canopy post and secure by
tightening the M4 set screw with the provided 2MM Allen
wrench.
For dual power feed canopies: Repeat steps 1-7 for the second
power feed cable.
2MM ALLEN
WRENCH
M4 SET SCREW
CANOPY POST
METAL SLEEVE
COAXIAL CABLE
Install the Power Feed Canopy
NOTE:
The low voltage wires should be present in the
electrical box prior to these steps. Refer to the instructions
provided with the remote transformer to install the remote
transformer and low voltage wires.
CANOPY
Connect the inner cable wire to one low voltage wire with a
wire nut.
Connect the other canopy wire to the other low voltage wire
with a wire nut.
For dual power feed canopies: Repeat steps 1-2 for the second
power feed cable.
NOTE:
Use the provided universal round crossbar when
the canopy holes do not line up with the electrical box
holes.
Place all wires and wire nut connections inside the electrical
box.
Tighten the two provided #8-32 flat head screws to the
electrical box holes with the 3/32 Allen wrench to secure the
canopy in place.
#8-32 FLAT
HEAD SCREW
3/32 ALLEN
WRENCH
1A
1C
1A
2A
5
6
3
4
1
2
5
7
1A
2B
5
6
1
2
5
5