Chatsworth Products LCD Monitors - Manual (Page 35)

35
Troubleshooting guide – LCD KVM Drawer
1. Is an interference signal on the LCD normal when shutting down the computer?
• In rare cases, interference may appear on the monitor. This may be caused by signal
rate of VGA card and is considered normal. The image quality can be improved by
adjusting the phase or pixel rate automatically or manually.
2. The membrane power light is not on.
• Press the power On / Off button on the LCD panel (LCD Adjustment Buttons) to check if
the monitor is in the ON mode.
• Check that the power cord is properly connected to the LCD KVM Drawer and power
outlet.
3. Screen image is not centered or sized properly.
• Adjust the H-position and V-position settings via On-Screen Display menu.
4. How do I adjust the resolution?
• To change monitor resolution, adjust settings in the computer by clicking Start -> Control
Panel -> Display. Select Setting tab to adjust the monitor resolution in the Desktop Area.
The resolution is determined by the display card in your computer:
- 640 x 480
- 800 x 600
- 1024 x 768
- 1152 x 864
- 1280 x 1024)
5. Is the LCD KVM Drawer hot-pluggable?
• The LCD KVM Drawer is hot-pluggable, but components of connected devices, such as
the servers and KVM Switches, may not be hot-pluggable. We suggest turning off the
power to all devices before connecting them. Apply power to connected devices again
only after the LCD KVM Drawer receives power.