Connecting to a power source – Samsung Sensory Pleasure NV3 User Manual

Page 11

Advertising
background image

《10》

Connecting to a Power Source

※These figures are measured under Samsung’s standard conditions and shooting

conditions and may vary depending on the user's methods.

Using the fully charged battery, Auto mode,
7M image size, Fine image quality, Shot to
shot interval : 30Sec.
Changing the zoom position between the Wide
and the Tele after every shot. Using the flash
on every second shot.Using the camera for 5
minutes and then Powering it off for 1 minute.

Using the fully charged battery

Using the fully charged battery LCD Off.

Approx. 240 MIN

Approx. 135 MIN

MP3

Movie

PMP

■ Number of images and battery life : Using the SLB-0837

Important information about battery usage.

● When the camera is not used, turn off the camera power.
● Please remove the battery if the camera will not be used for long periods.

Batteries can lose power over time and are prone to leaking if kept inside the camera.

● Low temperatures (below 0˚C) can affect the performance of the battery

and you may experience reduced battery life.

● Batteries will usually recover at normal temperatures.
● During extended use of the camera, the camera body may become warm.

This is perfectly normal.

● When you use earphones, do not remove the battery while the camera is

turning on. It may generate a loud noise.

INFORMATION

Still image

Using the fully charged battery

640X480 image size/ 30fps frame rate

Approx. 90 MIN

Approx. 100 MIN /

About 200 shots

Battery life / Number of

images

Based on the following shooting conditions

■ You can charge the rechargeable battery (SLB-0837) by using the SAC-45 KIT which

consists of the AC adapter (SAC-45) and the USB cable (SUC-C2). When the SAC-45
and SUC-C2 are combined, they can be used as an AC cable.

● Using an AC cable

: Connect the AC adapter to the USB cable. It can be

used as a power cable.

● Using a USB cable

: Remove the AC adapter (SAC-45). You can

download stored images to your PC (p.83) or supply
the power to your camera through the USB cable.

Important information about USB cable usage.
● Use a USB cable (SUC-C2) with the correct specification.
● If the camera is connected to the PC through a USB hub :

connect the camera directly to the PC.

● If the camera and other devices are connected to the PC at the same time :

remove other device.

● If the USB cable is connected to a port located on the front of the PC :

remove the cable and connect it to a port located on the back of the PC.

● If the USB port of the PC doesn't meet the Power output standard (5V, 500mA), the

camera may not be charged.

CAUTION

Advertising