B309, Assembly & installation instructions – Hubbardton Forge 207695 User Manual

Page 2

Advertising
background image

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

CASTLETON, VERMONT 05735

All designs and images ©1989-2013 Hubbardton Forge

®

. All rights reserved.

30409

Assembly & Installation Instructions

To Mount Fixture to Wall

(Figures 1 & 2)

(Continued)

6. Hold the fixture back (B) close to the wall mounting bracket

(D) and using suitable wire connectors (not provided)

connect fixture wires to supply wires (white to white and

black to black). Run a pigtail lead from the ground screw

(I) and cupped washer (H) to the electrical box and connect

all ground wires (bare copper or green to bare copper or

green).

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRES ARE EXPOSED.

7. Carefully tuck all wires behind the fixture back (B) and place

over the bracket (D) so the holes in fixture back (B) match

the threaded standoffs protruding from the wall mounting

bracket (D). Secure by threading the (2) #8 black screws (P)

through the holes in the fixture back (B) and into the stand

offs on the wall mounting bracket (D).

To Install Glass

(Figure 3)

Component Parts

A Fixture Front

K Glass (2)

L Rubber O-Ring (4)

M Knurled Ball (4)

Q Washer (4)

1. Knurled balls (M), rubber o-rings (L), and washers (Q) ship

installed. Remove from threaded studs on fixture front (A).

Save for later use.

2. Slide glass (K) over end of fixture front (A). Align holes in

glass with threaded studs on fixture front (A).

3. Slip glass (K) over threaded studs followed by washers (Q),

rubber o-rings (L) and knurled balls (M). Tighten knurled

balls (M) to secure glass.

Be sure not to over tighten.

4. Repeat for remaining glass.

B309

Oceanus 2-Light Sconce 207695

Page 2 of 3

(Figure 2)

G

(Figure 4)

(Continued)

J
H

K

A

Q
L

I
E
D
F
P
B

M

Advertising