Hubbardton Forge 134915 - Manual (Page 3)

Assembly & Installation Instructions
A263
Staccato Pendants 13-4910 & 13-4915 Page 3 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24825
Install to Ceiling
(Figure 5)
Component Part
E Ceiling Bracket
H Canopy
J Set Screw (2)
K Threaded Stud (2)
L #10 Wood Screws (8)
M Hex Nut
N Barrel Knobs (2)
O Cupped
Washer
1. Using wood screws (L) attach ceiling bracket
(E) to a structural member in the ceiling,
centering the bracket over the outlet box.
We've supplied wood screws with your
fixture; however, different materials and/or
construction methods may require different
fasteners. If in doubt, contact a qualified
electrician. Do not attach ceiling bracket
directly to outlet box.
2. Using suitable wire connectors (not provided)
connect fixture wires to supply (white to white
and black to black).
3. Using cupped washer (O) and hex nut (M) run
a pigtail lead from ceiling bracket to the
junction box. Raise canopy (H) and connect
all ground wires (bare copper or green to bare
copper or green). Push wires back into outlet
box.
Caution: Make sure wire connectors are
twisted on securely, and no bare wire is
exposed.
4. Slide fixture canopy (H) over threaded studs
(K) and push firmly to ceiling, making sure
that no wires are pinched between fixture
canopy and ceiling. Fasten with barrel knobs
(N). Be sure studs (K) are fully seated in
barrel knobs (N).
5. Once the fixture is fastened to the ceiling,
tighten the set screws (J) firmly with hex
wrench provided. Only after the set screws (J)
are tight should you install the glass. Be sure
to tighten set screws in both clutches.
6. Refer to instructions following to install glass.
(continued)
Illustration may not match every style.
(Figure 5)