Hubbardton Forge 204710 - Manual (Page 2)

Installation Instructions
B177
For Antasia Sconce 20-4710L, 20-4710R, 20-4710EL & 20-4710ER Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22737
To Mount Fixture to Wall with Standard 4" Box (Figure 2)
Component Parts
A Crossbar
B Threaded
Stud
C Barrel Knob
D Fixture Assembly
E Ground Screw
F Cupped Washer
G Wall Bracket
H 8-32 x 3/8” Screw
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten
the crossbar (A) to the electric box making sure
crossbar is level.
Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture
.
3. Thread stud (B) into the appropriate hole in the
crossbar (A). Adjust the stud to proper length to
ensure the fixture will fit snugly to the wall.
4. Attach wall bracket (G) using 8-32 x 3/8" screw
(H). Threaded stud installed in crossbar will pass
through wall bracket.
5. Hold the fixture assembly (D) close to the wall
and using suitable wire connectors, not
provided, connect fixture wires to supply (white
to white or ribbed and black to black or smooth).
Ground the crossbar (A) using the green ground
screw (E) and cupped washer (F) to secure a
pigtail lead to the bracket.
Caution: Make sure wire connectors are
twisted on securely, and no bare wire is
exposed.
6. Slide fixture assembly (D) over threaded stud
(B) and push firmly to wall, making sure that no
wires are pinched between fixture back and wall.
Fasten with barrel knob (C). Be sure threaded stud
(B) is fully seated in the barrel knob (C).
7. See instructions following to install glass.
(continued)
(Figure 2)