Hubbardton Forge 345610 - Manual (Page 2)

Assembly & Installation Instructions
G12
Meridian Post-Mount 34-5610 Page 2 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 26970 Rev A
To Install Inner Glass (Figure 2)
Component Parts
I Socket
J Nipple
K Plate
L Inner
Glass
Q Threaded Cap
1. Install light bulb (not included) into socket (I).
2. Remove threaded cap (Q) from nipple (J). Save for later use.
3. Place plate (K) over nipple (J) followed by inner glass (L).
4. Inner glass installation complete.
To Install Outer Glass (Figures 3 &4)
Component Parts
M 8-32 x 3/8” Screws (3)
N Spider
Assembly
O Outer Glass
P Top Cap
1. Loosen screws (M) so that
spider assembly (N) will turn
clock wise. It is not necessary
to completely remove the
screws (M) from fixture. Once
spider assembly (N) is loose
turn until it slips over the
heads of the screws (M). Set
aside for step 2 (Figure 4).
2. Slip glass (O) over spider
assembly (N).
3. Place top cap (P) over glass
(O) aligning screws (M) into
slots. Turn the top cap counter
clockwise until it stops.
4. Tighten screws (M).
5. Outer glass installation is
complete.
(continued)
(Figure 4)
(Figure 3)
(Figure 2)