Hubbardton Forge 364820 - Manual (Page 3)

Installation Instructions
A215
For Beacon Hall Chain-Hung Fixture 36-4820 & 36-4820F Page 3 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22881
To Install Outer Glass (Figure 4)
Component Parts
N Fixture Top
Q Glass Cage
R Outer Glass Plate
S Bottom Cover
T Washer
U Finial
W Outer
Glass
X O-Ring (2) (Packed in mounting kit)
Y Flat Head Screws (4)
1. Raise outer glass (W) up to fixture top (N) followed by outer
glass plate (R). Thread the four flat head (Y) screws into the
threaded standoffs until tight. Be careful not to over tighten.
2. Slip bottom cover (S), washer (T) and two o-rings (X) over
threaded nipple in outer glass plate (R). Thread finial (U) onto
threaded nipple until snug. Be careful not to over tighten.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 4)