Spektrum SPMR9900 DX9 - Manual (Page 10)

10 SPEKTRUM DX9 • TRANSMITTER INSTRUCTION MANUAL
EN
BINDING
Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier) code of a single specific
transmitter. You will need to rebind after the model programming is initially set up to fully program the model’s failsafe positions.
2. 3.
5. 6.
2. 3. 4.
6. 7.
1.
5.
1.
4.
Binding Using the Receiver and Receiver Battery
Binding Using the Receiver and ESC
2. 3.
5. 6.
2. 3. 4.
6. 7.
1.
5.
1.
4.
1. Lower throttle to the lowest position and make sure the
transmitter is powered off.
2. Insert the bind plug into the BIND/DATA port.
3. Insert the receiver battery into any open port. The receiver’s
LED will flash when the receiver is ready to bind.
4. While pressing the Bind button, power on the transmitter.
5. Release the Bind button after the receiver has stopped flash-
ing rapidly, once the receiver’s LED stays illuminated; this
indicates the receiver is bound to the transmitter. The screen
also provides binding information.
6. Remove the bind plug from the receiver.
1. Lower throttle to the lowest position and make sure the
transmitter is powered off.
2. Insert the bind plug into the BIND/DATA port.
3. Insert the ESC plug into the THRO port.
4. Connect battery to ESC and turn on ESC switch, if available.
The receiver’s LED will rapidly flash when the receiver is ready
to bind.
5. While pressing the Bind button, power on the transmitter.
6. Release the Bind button after the receiver has stopped
flashing rapidly, once the receiver’s LED stays illuminated; this
indicates the receiver is bound to the transmitter. The screen
also provides binding information.
7. Remove the bind plug from the receiver.