Nikon Speedlight SB-700 - Manual (Page 131)

H–2
Tips on Speedlight Care and Reference Information
H
Problem Cause Solution 0
Zoom head
position is not set
automatically.
The built-in wide panel
is in use or the Nikon
Diffusion Dome is
attached.
Remove the built-in
wide panel or the Nikon
Diffusion Dome.
E-14
E-9
Power zoom function
is canceled. Activate the power
zoom function.
E-25
Remote fl ash unit
does not fi re.
The distance between
the master fl ash unit and
the remote fl ash unit is
too long, or there is an
obstacle between them.
Redo the setup of the
master fl ash unit and
remote fl ash units. D-23
D-24
D-25
The light from the master
fl ash unit does not enter
the remote fl ash unit
light sensor window for
wireless remote fl ash.
The SB-700 does
not work properly.
Microcomputer may have
malfunctioned if this
occurs even when fresh
batteries are properly
installed.
Replace the batteries •
while the SB-700
is on.
If the problem
•
continues, contact
your retailer or Nikon
representative.
B-8
Nonstandard
display
The SB-700 does
not operate.
Thermal cut-out is active.
Wait until the SB-700
cools down.
E-31