Indesit PWDC7143W - Manual (Page 12)

12
GB
Care and maintenance
Cutting off the water and electricity
supplies
• Turn off the water tap after every wash cycle. This
will limit wear on the hydraulic system inside the
waher-dryer and help to prevent leaks.
• Unplug the waher-dryer when cleaning it and
during all maintenance work.
Cleaning the waher-dryer
The outer parts and rubber components of the
appliance can be cleaned using a soft cloth soaked
in lukewarm soapy water. Do not use solvents or
abrasives.
Cleaning the detergent dispenser
drawer
To remove the drawer,
press lever (1) and pull
the drawer outwards (2)
(see figure).
Wash it under running
water; this procedure
should be repeated
frequently.
Cleaning the pump
The waher-dryer is fitted with a self-cleaning pump
which does not require any maintenance.
Sometimes, small items (such as coins or buttons)
may fall into the pre-chamber which protects the
pump, situated in its bottom part.
 Make sure the wash cycle has finished and
unplug the appliance.
To access the pre-chamber:
1. take off the cover
panel on the front of
the machine by first
pressing it in the centre
and then pushing
downwards on both
sides until you can
remove it (see figures);
2
1
1
2
3
2. unscrew the lid by
rotating it anti-clockwise
(see figure): a little water
may trickle out. This is
perfectly normal;
3. clean the inside thoroughly;
4. screw the lid back on;
5. reposition the panel, making sure the hooks are
securely in place before you push it onto the
appliance.
Checking the water inlet hose
Check the inlet hose at least once a year. If there are
any cracks, it should be replaced immediately: during
the wash cycles, water pressure is very strong and a
cracked hose could easily split open.
  Never use second-hand hoses.