Installation guide, Installation tips wiring connections – Ultra Start 2250M User Manual
Page 4
![background image](/manuals/43535/4/background.png)
Recommended Pre-Installation Procedures
- Control module
- Remote transmitter(s)
- Antenna with built in program button and LED’s
- 6 pin main harness with dual 30amp power inputs
- 14 pin harness
- 3 pin - 2 wire keyless entry harness
- Multi-tone siren
- Hood pin safety switch
- Hood and window stickers
- Installation guide
- Owners manual
BEFORE STARTING INSTALLATION:
- Discuss the optional features with the customer.
- Take a few minutes to review the installation and owners manuals.
- Check if the vehicle has a factory security or anti-theft system.
*If equipped, inform the customer of addition parts and labour.
- Do a walk around the vehicle and check for any damage.
- If installing a LED discuss the placement with customer before installing.
Note: This remote starter is designed for fuel injected and diesel engines.
Recommended Installation Procedures
Under Hood Connections - Route the hood pin and tach wires through the firewall into the engine compartment. Always try to
pull the wires through a factory rubber grommet. If drilling through the firewall, BE CAREFUL. Check for obstructions on both
sides of the firewall. After drilling use a snap in grommet to protect the wires from sharp edges.
Proper Connections - Remote Starters can handle loads of up to 30 amps for extended periods of time. It is CRITICAL to
insure that ALL high current connections are properly soldered and insulated with quality electrical tape. Failing to insure proper
connections will result in warranty being VOID and can result in a FIRE. The manufacturer is not responsible for any such
damages. It only takes a few more minutes to do the job RIGHT.
Mounting The Control Module - Never mount the module in the engine compartment. Select a location under the dash to
install the main module. Be certain that the module is securely attached and does not obstruct any serviceable areas. Do not
force or jam the module into tight places instead of mounting. The module must be free from all moving parts such as brake,
clutch and gas pedal linkages. Do not place the module directly in front of a heater vent.
Installing the External Long Range Antenna - To insure the best possible reception, place the antenna in the center of the
windshield, behind the rear view mirror. Before attaching to the glass ensure that the surface is clean and dry. For best results
with range, place the antenna below the tint screen. Run the cable under the headliner and behind the A-pillar panel. Be careful
not to pinch the antenna cable. Plug the antenna into the BLUE connector on the Control Module.
NOTE: This step is not used on Alarm Only Units with no External Antenna.
Components
Testing The System - When the installation is complete, it will be necessary to test that the system is working correctly. The
system’s default programming will work on the majority of vehicles, but might need to be adjusted for some applications. If the
installation requires special timing or additional features, proceed to Program Mode.
ATTENTION: The Hood Pin Safety Switch MUST always be connected!!
NOTE: Always inform user to place system in Service Mode before any service
Work is performed on the vehicle.
INSTALLATION GUIDE
INSTALLATION TIPS
WIRING CONNECTIONS