Sony DSLR-A330 - Manual (Page 162)

162
Cannot print images.
• Check that the camera and the printer are properly connected using the USB
cable.
• RAW images cannot be printed.
• Images shot using cameras other than this camera or images modified with
a computer may not be printed.
“---- -- --” is printed on the date-inserted part of the image.
• Images that do not have the recording data/time information cannot be
printed with the date inserted. Set [Date imprint] to [Off] and print the
image again (page 149).
Cannot print the image at the size selected.
• Disconnect the USB cable and reconnect it whenever you change the paper
size after the printer has been connected to the camera.
• The print setting of the camera differs from that of the printer. Change the
setting of either the camera (page 149) or the printer.
Cannot operate the camera after canceling printing.
• Wait for a while as the printer is carrying out the cancellation. It may take
some time depending on the printer.
The lens gets fogged.
• Moisture condensation has occurred. Turn off the camera and leave it for
about an hour before using it (page 167).
The message “Set date and time?” appears when you turn on the camera.
• The camera has been left unused for sometime with a low battery or no
battery pack. Charge the battery pack and set the date again (pages 25, 167).
If the date setting is lost every time the battery pack is charged, consult your
Sony dealer or local authorized Sony service facility.
The number of recordable images does not decrease or decreases two at
a time.
• This is because the compression rate and the image size after compression
change depending on the image when you shoot a JPEG image (page 119).
Others