Recording from a microphone, To select microphone sensitivity – Sony MZ-N1 User Manual
Page 34
34
3
Turn the jog dial repeatedly until
“REC-Posi” flashes in the display,
and then press to enter.
4
Turn the jog dial repeatedly until
“From End” flashes in the display,
and then press to enter.
To start recording over the
current contents
Select “From Here” in step 4.
z
To temporarily record without recording over
the current contents, press END SEARCH
before the start of recording. The recording will
begin after the last track, even if “REC-Posi” is
set to “From Here” (factory setting). The
remaining recordable time on the disc will
appear in the display when you press END
SEARCH.
Notes
• The setting will remain even after the power is
turned off.
• If you start recording while the recorder is in
play-pause mode, the recording will begin
from the point at which it is paused even when
the “REC-Posi” is set to “From End”.
Recording from a
microphone
1
Turn the power of the stereo
microphone off, and then connect it to
the MIC (PLUG IN POWER) jack.
The recorder changes to microphone
input automatically.
2
Press and slide REC to the right.
For other operations, see “Recording
an MD right away! (Synchro-
recording)” (page 19).
To select microphone
sensitivity
1
While the recorder is recording or
stopped, press the jog dial.
2
Turn the jog dial until “MIC SENS”
flashes in the display, and then press
to enter.
3
Turn the jog dial until “SENS HIGH”
or “SENS LOW” appears in the
display, and then press to enter.
SENS HIGH: When recording a soft
sound or a sound in the distance.
SENS LOW: When recording a loud
sound or a sound at close range.
Notes
• The recorder automatically switches input in
the following order; optical input, microphone
input, and analog input. You cannot record
through the microphone while an optical cable
is connected to the LINE IN (OPT) jack.
• The microphone may pick up the operating
sound of the recorder itself. Use the
microphone away from the recorder in such
cases. Do not use a microphone with a short
connector, as this may cause the operating
sound of the recorder to be picked up.
• Only the left-channel sound is recorded when
a monaural microphone is used.
to MIC (PLUG IN POWER)
Stereo
microphone*
REC
Jog dial