Sony CPD-200GS - Manual (Page 7)

7
Getting Started
F
EN
ES
C
Getting Started
Connecting Your Monitor’s
Speaker
You can listen to music, sounds, and other audio files using
the speaker in your monitor.
Connect the AUDIO IN jack to the audio out jack of your
computer’s sound card using the miniplug cord (supplied).
Adjusting the sound
1 Press the MENU button.
The MENU OSD appears.
2 Press the ¨./> and >?// buttons to select “™
SOUND,” and press the MENU button again.
The SOUND OSD appears.
Note
While muting the sound, the mark appears in the SOUND OSD
instead of the Á mark. Increase the volume to cancel the mark
and activate the speaker.
3
Press the >?// buttons to adjust the volume.
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.
To reset, press the RESET button while the OSD is on.
To mute the sound
Press the MUTING button.
No sound comes from the speaker.
The
mark appears at the bottom of the screen.
To cancel, press the MUTING button again.
Using the headphones jack
You can listen to the audio signals from your computer
using headphones (not supplied). The speaker turns off
when headphones are connected to the headphones jack.
Adjust the volume using the SOUND OSD.
Note
If the volume from the speaker is too low, increase the output level
(average of 500 mv) of the computer.
AUDIO IN
AUDIO IN jack 2 Headphones jack
MENU
EXIT
CENTER
SIZE
GEOM
COLOR
SOUND
ZOOM
SCREEN
OPTION
OK MENU
MENU
SOUND
26
MUTING