Technical data, Installation, Location – AEG A62000GNW0 User Manual

Page 14

Advertising
background image

6.

After approximately 20 minutes the drain hose at the rear of the cabinet starts to dis-

charge water into the drip tray.

7.

To prevent the water overflowing from

the drip tray dry with a sponge.

8.

The defrosting process ends when the

water stops dripping. It may take several

hours if the problem started long before.

9.

Move the appliance to the original posi-

tion.

10. Clean and dry the inside of the appli-

ance.

11. Connect the mains plug into the mains

socket.

12. Switch on the appliance.

TECHNICAL DATA

Dimension of the recess

Height

1600 mm

Width

600 mm

Depth

630 mm

Rising Time

21 h

Voltage

230-240 V

Frequency

50 Hz

The technical information are situated in the rating plate on the internal left side of the

appliance and in the energy label.

INSTALLATION

WARNING!

Read the "Safety Information" carefully for your safety and correct operation of the appli-

ance before installing the appliance.

Location

The appliance should be installed well away from sources of heat such as radiators, boilers,

direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To

ensure best performance, if the appliance is positioned below an overhanging wall unit, the

minimum distance between the top of the cabinet and the wall unit must be at least 100

mm . Ideally, however, the appliance should not be positioned below overhanging wall

14

Technical data

Advertising