Gs panel series and operation, Initial start-up – Balboa Water Group GL/GS 230V User Manual
Page 36
36
TEMP CONTROL (26°C - 40°C / 80°F - 104°F)
The last measured water temperature is constantly
displayed.
The water temperature displayed is current only when the
pump has been running for at least 2 minutes.
On panels with a single “Temp” or “Set” button, to display
the set temperature, press the button once. To change the
set temperature, press the button a second time before the
display stops flashing.
Each press of the button will continue to either raise or
lower the set temperature. If the opposite direction is
desired, allow the display to revert to the current water
temperature. Press the button to display the set temperature,
and again to make the temperature change in the desired
direction.
GS Panel -- 500 Series and Operation
Initial Start-up
Your spa will enter Priming Mode ( ) when it is energized.
During Priming Mode, press “Jets” button(s) repeatedly and
be sure all pumps are free of air. Priming Mode lasts less
than 5 minutes. Press “Temp” to exit. After Priming Mode,
the spa will run in Standard Mode (see Mode section).
Some panels may not have a “Temp” button. On these
panels the “Set”, “Warm”, or “Cool” buttons are used.
The pump responsible for heating and filtration (pump 1
low-speed on non-circ system, or the circ pump on circ
systems) will be referred to simply as the pump.
In multi-button sequences, if the buttons are pressed too
quickly in sequence, they may not register.
Te
Te
mp
mp
p
p
p
Je
Je
J
J
ts
ts
Bl
Bl
ow
ow
er
er
Li
Li
gh
gh
g
g
g
t
t
Warm
Cool
Mode
Jets
Blower
Light
Warm
Cool
Mode/Prog
Jets
Blower
Light
Time
500SZ Series Panel
500Z Series Panel
500DZ Series Panel
Note: Button shapes and labels may vary.
Note: Button shapes and labels may vary.
Note: Button shapes and labels may vary.
Please refer to the User Guides for additional information.
500 Z Series User Guide: P/N 40789
500 SZ Series User Guide: P/N 40790
500 DZ Series User Guide: P/N 40788