Vaddio CeilingVIEW 70 Manual User Manual
Page 7
CeilingVIEW 70 PTZ - Document 010-2304-000 Rev.E
Page 7 of 14
Vaddio supplies this control specification for the CeilingVIEW 70 PTZ camera.
This VISCA control set (as used in Sony EVI cameras) is used in conjunction with
additional Vaddio control commands (see comment section on Table 1) for added
functionality of the camera lift.
Communication Speed: 9600 bps (default)
Start bit:
1
Stop bit:
1
Data bits:
8
Parity:
None
The control codes for the CeilingVIEW 70 PTZ are the same codes used with the
EVI-D70 pan/tilt/zoom camera. Vaddio is not translating these codes and does
not add any translation or memory capability to enable use of the EVI-D70 camera
as a main or auxiliary camera with videoconferencing system codecs or the
associated IR remote controllers of the codecs.
For best control results, use the provided RM-EV100 IR Remote Controller or the
VISCA Commands (detailed in Table 1 below) with an external control system.
Table 1: VISCA Command List (Partial)
RS-232
Command Set
Command
Command Packet*
Comments
AddressSet
Broadcast
88 30 01 FF
Address setting
IF_Clear
Broadcast
88 01 00 01 FF
I/F Clear
CommandCancel
8x 2p FF
p: Socket No.(=1or2)
On
8x 01 04 00 02 FF
Power ON
CAM_Power
Off (Standby)
8x 01 04 00 03 FF
Power OFF
Stop
8x 01 04 07 00 FF
Tele(Standard)
8x 01 04 07 02 FF
No
Wide(Standard)
8x 01 04 07 03 FF
Tele(Variable)
8x 01 04 07 2p FF
p=0（Low）～7（Fast）
Wide(Variable)
8x 01 04 07 3p FF
CAM_Zoom
Direct
8x 01 04 47 0p 0q 0r 0s FF
pqrs: Zoom Position
D-Zoom On
8x 01 04 06 02 FF
Digital Zoom ON/OFF
CAM_Dzoom
D-Zoom Off
8x 01 04 06 03 FF
Stop
8x 01 04 08 00 FF
Far(Standard)
8x 01 04 08 02 FF
Near(Standard)
8x 01 04 08 03 FF
Far(Variable)
8x 01 04 08 2p FF
p=0（Low）～7（High）
Near(Variable)
8x 01 04 08 3p FF
Direct
8x 01 04 48 0p 0q 0r 0s FF
pqrs: Focus Position
Auto Focus
8x 01 04 38 02 FF
AF ON/OFF
Manual Focus
8x 01 04 38 03 FF
CAM_Focus
Auto/Manual
8x 01 04 38 10 FF
RS-232
COMMAND LIST
Communication
Specification
*Communication Example:
For the VISCA Packet “8x 01 04 07 03 FF”
(CAM_Zoom_Wide), “x” corresponds with
the number and order of the camera in the
control chain (daisy chain) where x = 1 for
the first camera, x = 2 for the second
camera, etc…
Control
Disclaimer
Command List