Minka Group F734-GL - Manual (Page 18)

9
Fig. 17
WARNING: Shut off the power supply before removing or replacing lamp. In handling of halogen
bulb, care should be taken not to touch it with your bare hands. Oil residue will shorten the life of the
halogen bulb. If you accidentally come into contact, wipe thoroughly with a clean, lint-free, cotton cloth.
Allow the bulb to cool for 10 minutes before changing the bulb. Use light bulb in accordance with the
fan's specification. DO NOT EXCEED THE MAXIMUM WATTAGE RATING.
ATTENTION: The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt limiting
device. If lamping exceeds 190 watts, the ceiling fan's light kit will shut off automatically.
Step 1. Install 1x75W halogen bulb (included) into bulb socket.
Step 2. Raise glass shade up against bottom of fan housing and secure it to the fan by turning the glass
shade clockwise until snug. DO NOT OVERTIGHTEN. (Fig. 17)
NOTE: The metal light cover included with your fan is an option to replace the glass for the light in the
event that you prefer not to use the light feature of your fan. The metal light cover is not necessary for
the light operation; it can be saved for later use if desired.
INSTALLING THE LIGHT BULB & GLASS SHADE
GLASS
SHADE
75 W HALOGEN BULB
B U L B R IT E 12 0V
15 0W