Martin Universal Design U-DS40 SMART TABLE - Manual (Page 5)

HEIGHT ADJUSTMENT:
To adjust the height of your table - loosen the knobs on the collars found on the base of the table and lift the table top to
desired height.
TILT ADJUSTMENT:
To adjust the tilt of your table top, loosen the knobs on the side of the legs and hold onto table top and tilt to desired angle.
Tighten knobs on legs to secure.
LEVELING FLOOR GUIDES:
If your floor is uneven, you can adjust the floor guides by loosening the floor guides
to make up for the uneven floor.
4444 Lawton Avenue, Detroit, MI 48208 USA • Tel:(313)895-0700/Fax:(313)895-0709
Email: [email protected] • visit us at www.MartinUniversalDesign.com
03/2009- RPI Pg. 5
U-DS40 SMART TABLE • Assembly Instructions
Attach Pencil Ledge (part I) to the front edge of the Top
using [2] Screws (part N). Tighten to secure.
NOTE: Slightly loosen screw to allow for raising or
lowering of pencil ledge.
SEE FIG 9 & FIG 9B
STEP 9] Attach Pencil Ledge
FIG 9B - ZOOM of Pencil Ledge attachment
FIG 9
STEP 10] Tighten All Screws and Bolts Once complete, double check all screws and bolts to
make sure they are secure.
Enjoy Your New SMART TABLE!