Martin Universal Design U-115N MIDDLEWEIGHT FOLDING EASEL - Manual

U-115N/L Middleweight Folding Easel
ASSEMBLY INSTRUCTIONS
HARDWARE PARTS
1 ea. ....... 3” Bolts [A]
2 ea. ....... 2½” Bolts [B]
3 ea. ....... 2” Bolts [C]
2 ea. ....... 1” Wood Screws [D]
2 ea. ....... ½” Wood Screws [E]
3 ea. ....... Washers [F]
3 ea. ....... Wingnuts [G]
2 ea. ....... Plastic Channel Guides [H]
2 ea. ....... Plastic Knobs [I]
1 ea. ....... Metal Stay [J]
WOOD PARTS
1 ea. ....... Channelled Center Column
1 ea. ....... Rear Spike Leg
........ with attached wooden block
1 ea. ....... Base Foot
1 ea. ....... Upper Canvas Support
1 ea. ....... Lower Canvas Support
MAKE SURE CARTON CONTAINS THE FOLLOWING PARTS
Layout all wood parts
on hard flat floor
with all holes facing up.
STEP 1. Before Attaching Rear Spike Leg.
MAKE SURE rear leg is in this position before
attaching to Channelled Center Column.
Continue by aligning screw holes and proceed
by screwing in 2 ea. 1” wood screws [D] into
wood block and then into upper cross member.
FIG 1
Martin Universal Design, Inc. • 4444 Lawton Avenue, Detroit, MI 48150 USA
Tel:(313)895-0700 • Fax:(313)895-0709 • E-mail:[email protected]
Channelled Center Column
Rear Spike Leg
Upper Canvas Support
Lower Canvas Support
Rear spike leg w/
woodedn block
+
+
STEP 2. Attaching Metal Stay [J] to Easel
MAKE SURE Positioning of metal stay [J] is
CORRECT as shown below in FIG. 2.
Align holes in metal stay with pre-tapped holes in
center column. Attach using 2 ea. 1/2” wood
screws [E] and tighten.
Channel in
center column
+ +
Metal Stay in Correct Position
FIG 2
Channelled
Center Column
Base Foot
[C] 3ea. -2” Bolts
[B] 2ea. - 2½” Bolts
[D] 2ea.
1” Wood Screws
[F] 3 ea. - Washers
[G] 3 ea. - Wingnuts
2ea.
[H] Plastic Channel Guide
[I] 2ea.
Plastic Knobs [J] 1ea. - Metal Stay
[E] 2ea.
½” Wood Screws
[A] 1ea. - 3” Bolt