Kramer Electronics 104LN - Manual (Page 10)

104LN - Connecting the 104LN 7
4 Connecting the 104LN
Always switch off the power to each device before connecting it to your
104LN. After connecting your 104LN, connect its power and then
switch on the power to each device.
To connect the 104LN 1:4 Differential Video Line Amplifier, as the example in
Figure 3 illustrates, connect the following:
1. Connect a composite video source (for example, a satellite decoder and
receiver) to the INPUT BNC connector.
2. Connect the four OUT BNC connectors to up to four composite video
acceptors, as follows:
 Connect the OUT 1 connector to video acceptor 1 (for example,
a video recorder)
 Connect the OUT 2 connector to video acceptor 2 (for example,
a video display)

Connect the OUT 3 connector to video acceptor 3 (for example,
a video display)
 Connect the OUT 4 connector to video acceptor 4 (for example,
a video display)
3. Adjust the output signal level and/or cable compensation equalization level,
if required.
4. If the image appears noisy, set the INPUT GROUND to either ON or FLOAT
to lower the noise level.
i