Kramer Electronics PT-5R/T - Manual (Page 9)

6 PT-5T/R - Connecting and Using the PT-5T/R IR Extender/Repeater
4 Connecting and Using the PT-5T/R IR
Extender/Repeater
4.1 Identifying the IR Receiver and IR Emitters
The receiver and emitters can be identified by their size and shape. The receiver is
large and trapezoidal in shape; the emitters are small and rectangular in shape
with a rounded top. Both have a 2m (6.6ft) cable attached terminated with a
3.5mm mini jack.
Figure 3: IR Receiver and Emitter
4.2 Connecting the PT-5T/R IR Extender/Repeater
To connect the PT-5T/R IR Extender/Repeater as illustrated in the example in
Figure 4 :
1. Plug the IR receiver into the IR IN 3.5mm mini jack on the front panel of the
PT-5T.
2. Plug up to two IR emitters into the OUT 1 and OUT 2 3.5mm mini jacks on
the front panel of the PT-5T.
3. Mount each of the IR emitters so that each points at and is within range of
the relevant media device to be controlled.
4. Plug up to three IR emitters into the OUT 1, OUT 2 and OUT 3 3.5mm mini
jacks on the front panel of the PT-5R.
5. Mount each of the IR emitters so that each points at and is within range of
the relevant device to be controlled.