Kramer Electronics VS-1616D - Manual (Page 32)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Using the Configuration Menus
28
3. Press ENT.
The current EDID matrix configuration is displayed. In this example, input 07
is assigned to output 05, all other EDID values are default.
05 06 07 08 09 10
05
8.1.4 Setup Menu—9: Delay, Setting for an Output
This option sets the time delay for an output which lapses between entering a
switching action and the execution of the action. This delay can be set for each
output independently. The delay is defined in units of 200ms and ranges from 0 to
15, providing delays of between 0 and 3 seconds (15 x 200ms = 3 seconds).
To set the execution delay for an output:
1. Press MENU.
The Setup Menu options are displayed.
2. Press 9 (DELAY) on the numeric keypad (see Figure 2 ).
The output/delay times display is shown.
3. Using the numeric keys, enter the output (in this example, 03).
The following is displayed:
01 02 03 04 05 06 07 08
DLY__ =>out03
4. Using the numeric keys, enter the number of delay units.
5. Press TAKE.
The selected output delay is set.
The display reverts to the output/input display.
8.1.5 Setup Menu—4: store setup XX, Storing the Setup in a Preset
This option stores the current setup in a preset (1 to 59).
To store the current setup in a preset:
1. Press MENU.
The Setup Menu options are displayed.
2. Press 4 (STO) on the numeric keypad (see Figure 2 ).
The following is displayed:
store => __
3. Using the numeric keys, enter the preset (1 to 59) in which to store the current
setup.
The following is displayed:
Wait …..
After a few seconds, if the preset is not empty, the following is displayed:
SETUP NOT EMPTY
CONFIRM