Kramer Electronics VP-790 - Manual (Page 25)

VP-790 Warp Generator – Preparing a Grid 23
5.4.2
17B
Connecting to the VP-790 via the Warp Generator Software
To connect to the VP-790 via the Warp Generator Software to upload or update the
Warp map, do the following:
1. Click the Connect button on the top left hand side of the Warp Generator
main window (see
U
Figure 23
U
).
Figure 23: Click the Connect Button
2. One of two windows appears:
 The Connect to Unit window, if you are connecting for the first time or
via a new IP number, see
U
Figure 24
U
.
Type the IP address, click on the Add an Address button, select the IP
number in the area below and then click the Connect to Unit button
 The Auto Connect window, if you have been using the same IP number,
(see
U
Figure 2
U
5 ).
Click the Yes button
Figure 24: The Connect to Unit Window Figure 25: The Auto Connect Window