Kramer Electronics FC-24ETH - Manual (Page 10)

6 Defining the FC-21ETH, FC-22ETH and
FC-24ETH Ethernet Controllers
4 Defining the FC-21ETH, FC-22ETH and
FC-24ETH Ethernet Controllers
4.1 Defining the FC-21ETH Ethernet Controller
Figure 1 defines the front panel of the FC-21ETH.
Figure 1: FC-21ETH Ethernet Controller Front Panel
# Feature Function
1 ON LED Lights green when the unit is on
2
ETHERNET
LEDs
CONNECTED Lights yellow when the Ethernet port is connected
DATA Flashes green when data is transferred over the Ethernet
link
3
SERIAL
LEDs
RS-232 Lights green when RS-232 is selected
RS-485 Lights green when RS-485 is selected
4 Tx Flashes red when the serial port is transmitting data
Rx Flashes green when the serial port is receiving data
5
DHCP
ON LED Lights green when DHCP is selected
6 Button Press to toggle the selection between DHCP and static IP
addressing, (see
Section 8.3 )
7 FACTORY DEFAULT Button Press and hold while power-cycling the device to reset to
factory default parameters, (see Section 10 )