Antennas Direct SR15 Antenna - Manual

SR15 Assembly Instructions
Attach brass colored tilt bracket assembly using sup-
plied bolts and wing nuts to antenna boom as shown.
Locate the single bolt and wing nut that passes
through the antenna boom. (Indicated in picture with
arrow) This will be used to secure the two reflector
elements.
Unfold and Snap into place the driven elements. These
are folded for shipping.
Attach the two reflector elements by sliding their
attach plates through the supplied bolt. (As indicated
by the arrow)
Next, tighten the wing nut so that the reflector ele-
ments are firmly in place. The reflectors should be
angled forward towards the direction of the transmit-
ting towers
Assembled SR15, right: Shown with optional “J”
mount. Sold separately
Make sure narrow end is aimed at transmitting towers.
Installation Tips
Questions? Call Terrestrial Digital: 877-825-5572
Warning! Installation of this antenna
near power lines is dangerous.
If your cable run is greater than 75’, A UHF pre-
amplifier may be required.
UHF signals are line of sight. Get as much eleva-
tion on the antenna as practical.
Attic installations will cut 40% -50% of your
signal strength.