Revolabs FLX2 VoIP - Manual

Revolabs FLX2
TM
VoIP – Quick Setup Guide
Congratulations on your purchase of the Revolabs FLX2 TM VoIP Wireless Conference Phone, the first wireless
VoIP Conference phone. This system utilizes state of the art technology providing high bandwidth audio and
enabling clear, reliable, untethered communications with your telephone, PC, mobile device, and video
conferencing system.
The Revolabs FLX2 Conference Phone provides enhanced freedom for telephone and video conferences by
allowing independent locations of the microphones and the speaker during the call.
Unpacking
Your Revolabs FLX2™ Conference Phone package
contains the following items. When unpacking the
system be sure to take inventory of all parts to ensure
that nothing is missing. If parts are missing, please
contact your retailer.
Revolabs FLX2 Conference Phone components are
partially charged. Please charge the Speaker, the
Microphones, and the Dialer for at least 8 hours or
overnight before using the system.
Contents
FLX2 Base Station
FLX2 Charger Base
FLX Speaker
FLX Dialer
2 FLX Microphones (lapel – omni –
directional microphone shown)
12-15V AC adapter for the Charger Base
RJ45 Ethernet Cable
Connecting the Base Station
Place the Base Station close to the Ethernet outlet you want to use for the conference
phone. Connect the Base Station to the network using the provided Ethernet cable. The
Base Station is powered using Power over Ethernet (PoE). If the base station does not
power up after you connect it to the network outlet, this outlet might not be providing
PoE. Please check with your IT department that PoE is available.
If your network does not support PoE, Revolabs provides a power injector that can be
bought through your reseller, which adds the necessary power to that Ethernet
connection.
Connecting the Charger Base
Place the Charger Base at a location where you can easily access the Microphones and
the Speaker for your conference calls, e.g. on a side board, a desk, or the conference
table.
Connect the Charger Base to a power outlet using the provided 12-15V power supply.
Place the Speaker, the Microphones, and the Dialer in the respective openings of the
Charger Base to charge them.
The Dialer and Speaker will automatically connect to the Base Station after a short time
if it is powered up. You will hear a confirmation chime from the Speaker once the
system is ready for use. The Microphones only connect when taken out of the Charger
Base, or if the multi-function button is pressed while in the Charger Base. If the Speaker
or the Dialer are not powered up, take them out of the Charger Base for a few seconds
and put them back in. This will switch on the component.
Phone configuration
Before using the FLX for the first time you will need to select the system language. The six options are
English, Español (Spanish), Français (French), Deutsch (German), Italiano (Italian), and Português
(Portuguese). Highlight the language of your choice, and press either “Enter” or “Select” on the Dialer
to select it. Once a language is select, the system will use that language for all screen contents.
Please ensure that you select the right language. If you need to change the selected language later on,
this can be done in the advanced setup menu of the handset.