Lenovo ThinkServer RD530 - Manual (Page 97)

11. Align the two screw holes in the low-profile bracket with the corresponding screw holes in the RAID card
and then install the screws to secure the bracket.
Figure 44. Installing the low-profile bracket to the RAID card
12. Position the RAID card near the PCI Express card slot. Ensure that the left edge of the RAID card is
inserted into the notch of the RAID card retention bracket 1 . Then, carefully press the RAID card
straight into the slot until it is securely seated and the low-profile bracket also is secured by the riser
card assembly 2.
Figure 45. Installing the RAID card
13. Connect signal cables to the connectors on the new RAID card and the connectors on the hot-swap hard
disk drive backplane. See your note and “Mini-SAS to mini-SAS signal cable connections” on page 32.
14. Reinstall the riser card assembly 2. The procedure is similar to that of the riser card assembly 1. See
“Replacing the riser card assembly 1” on page 131.
15. If you are instructed to return the old RAID card, follow all packaging instructions and use any packaging
materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to “Completing the parts replacement” on page 135. Then, configure
RAID for your server. See “Configuring RAID” on page 58.
Chapter 6 . Installing, removing, or replacing hardware 85