Konica Minolta BIZHUB 223 - Manual (Page 140)

bizhub 423/363/283/223 7-8
7.1 [System Settings] 7
* This item is displayed only when a Hard Disk is installed.
7.1.7 [Expert Adjustment]
Make adjustments so that output quality is increased.
%
Press the Utility/Counter key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment].
[Changing the "From" Ad-
dress] [Login User Address]
[Change Registered Over-
lay] * [Allow]
[Biometric/IC Card Infor-
mation Registration] * [Restrict]
[Restrict Broadcasting] [No]
Factory default
Settings
[AE Level Adjustment] Configure the initial value for AE (auto exposure). The higher the setting,
the more that the original background is emphasized.
[Printer Adjustment] Adjust the starting print position and defective print images caused by pa-
per type features.
d
Reference
The starting print position is factory-adjusted. Normally, you
are not required to change the set values.
[Leading Edge Adjustment] p. 7-11
[Centering] p. 7-11
[Leading Edge Adjustment (Du-
plex Side 2)] p. 7-11
[Centering (Duplex 2nd Side)] p. 7-11
[Erase Leading Edge] Adjust leading edge erase width.
For details on displaying this item,
contact your service representative.
[Vertical Adjustment] Adjust the feed direction zoom ratio of
paper types.
For details on displaying this item,
contact your service representative.
[Media Adjustment] p. 7-12