Konica Minolta magicolor 1690MF - Manual (Page 61)

Sending a Fax Manually 3-18
3
Pick up the handset and check that the dial tone can be heard.
4
Specify the fax number of the recipient by using the telephone to dial the
fax number.
"
The fax number of the recipient can also specified using the keypad in
the control panel of this machine.
"
If Pulse is selected as the telephone line type, press the key to tem-
porarily change the line type to Tone.
5
After finishing talking on the phone, the recipient should press the neces-
sary key to start receiving the fax.
Once the recipient’s fax machine is ready, a beep is sounded.
6
Press the Start key to begin scanning and sending the fax.
7
Replace the handset to its cradle.
"
To stop the transmission, press the Stop/Reset key. A message
appears, requesting confirmation to cancel the setting. Select YES,
and then press the Select key.
Sending a Fax Manually Using the On Hook Key
"
Manual transmission cannot be used together with duplex (dou-
ble-sided) document transmission.
1
Load the document into the ADF.
"
When sending a fax manually, load the document into the ADF. An
error will occur if the document is placed on the original glass.
"
For details on loading the document into the ADF, refer to “Sending a
Fax Using the ADF” on page 3-2.
2
If desired, adjust the image quality.
"
The document image quality can be adjusted. For details, refer to
“Adjusting the Image Quality” on page 3-6.
3
Press the On hook key.
4
Specify the fax number of the recipient.
"
The keys for registered destinations can be used even if the On hook
key has been pressed. For details, refer to “Specifying a Recipient” on
page 3-7. (Group dial destinations cannot be specified.)
"
If Pulse is selected as the telephone line type, press the key to tem-
porarily change the line type to Tone.