AEG L61470WDBI - Manual (Page 30)

Problem Possible cause Possible solution
Leakages from the drain
pump. Make sure that the drain pump
filter is tight.
The water drain hose is
damaged. Make sure that the water inlet
hose has no damages.
You cannot open
the appliance
door. The washing pro-
gramme is in operation. Let the washing programme
end.
There is water in the
drum. Set the drain or the spin pro-
gramme.
The appliance
makes an unusual
noise. Incorrect level of the ap-
pliance. Adjust the level of the appli-
ance. Refer to 'Installation'.
You did not remove the
packaging and/or the
transit bolts. Remove the packaging and/or
the transit bolts. Refer to 'Instal-
lation'.
The load is very small. Add more laundry in the drum.
The appliance fills
with water and
drain immediately. The end of the drain
hose is too low. Make sure that the drain hose is
in the correct position.
The washing re-
sults are not satis-
factory. The detergent you used
was not sufficient or cor-
rect. Increase the detergent quantity
or use a different one.
You did not remove the
stubborn stains before
you wash the laundry. Use special products to remove
the stubborn stains.
Incorrect temperature
was set. Make sure that you set the cor-
rect temperature.
Too much laundry load. Decrease the laundry load.
The appliance
does not dry or
does not dry cor-
rectly. The water tap is not
turned on. Turn the tap on.
The drain filter is clog-
ged. Clean the drain filter.
There is too much laun-
dry in the drum. Reduce the laundry load.
You have set a wrong
dryness level or drying
time. Set additional drying time.
The laundry is full
of different col-
ours fluff. The fabrics washed in
the cycle before re-
leased fluff of different
colours. • The drying phase helps to re-
move some fluff.
• Clean the laundry with a fluff
remover.
30 www.aeg.com