AEG F55002VI0P - Manual (Page 11)

A B D
30
20
C
M AX
1 2 3 4
+ -
B
2 0 0 3
A D
C
CAUTION!
Use only detergents for dish-
washers.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compart-
ment (A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
7.3 Combi detergent tablets
These tablets contain detergent, rinse
aid and other added agents. Be sure
that these tablets are applicable to the
water hardness in your area. Refer to the
instructions on the packaging of the
products.
When you use tablets, that contain salt
and rinse aid, do not fill the salt contain-
er and the rinse aid dispenser. The rinse
aid indicator always comes on if the rinse
aid dispenser is empty.
1. Adjust the water softener to the low-
est level.
2. Set the rinse aid dispenser to the
lowest position.
If you stop to use the combi
detergent tablets, before you
start to use separately
detergent, rinse aid and
dishwasher salt, do these
steps:
1. Press the on/off button to activate
the appliance.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the released quantity of rinse
aid.
7.4 Setting and starting a
programme
Setting mode
The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation, all the programme
indicators are off and the end indicator
flashes.
If the control panel shows other condi-
tions, press and hold the programme
button until the appliance is in setting
mode.
ENGLISH
11