AEG SKZ71800F0 - Manual (Page 13)

6.1 Replacing the lamp
The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center.
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
7. INSTALLATION
7.1 Positioning
WARNING!
If you are discarding an old appli-
ance that has a lock or catch on
the door, you must ensure that it
is made unusable to prevent
young children being trapped in-
side.
The appliance shall have the
plug accessible after installation.
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
7.2 Electrical Connection
CAUTION!
Any electrical work required to
install this appliance should be
carried out by a qualified electri-
cian or competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any li-
ability should these safety meas-
ures not be observed.
1 2
3
4
5
The wires in the mains lead are
coloured in accordance with the
following code:
1 Green and Yellow: Earth
3 Brown: Live
5 Blue: Neutral
As the colours of the wires in the mains
lead of this appliance may not corre-
spond with the coloured markings iden-
tifying the terminals in your plug, pro-
ceed as follows:
1. Connect the wire coloured green
and yellow to the terminal marked
either with the letter “E“ or by the
earth symbol
or coloured green
and yellow.
ENGLISH
13