Technical data, Installation, Replacing the lamp – AEG SKS68849F1 User Manual

Page 43: Closing the door, Positioning

Advertising
background image

Problem

Possible cause

Solution

The temperature in the ap-

pliance is too low/high.

The temperature regulator is

not set correctly.

Set a higher/lower temperature.

The door is not closed correctly. Refer to "Closing the door".

The product temperature is too

high.

Let the product temperature de-

crease to room temperature be-

fore storage.

Many products are stored at

the same time.

Store less products at the same

time.

The temperature in the re-

frigerator is too high.

There is no cold air circulation

in the appliance.

Make sure that there is cold air

circulation in the appliance.

Replacing the lamp

The appliance is equipped with a longlife LED interior light.

Only service is allowed to replace the lighting device. Contact your Service Center

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.

TECHNICAL DATA

Dimension of the recess

Height

1030 mm

Width

560 mm

Depth

550 mm

The technical information are situated in the rating plate on the internal left side of the

appliance and in the energy label.

INSTALLATION

Positioning

WARNING!

If you are discarding an old appliance that has a lock or catch on the door, you must

ensure that it is made unusable to prevent young children being trapped inside.

The appliance shall have the plug accessible after installation.

Technical data

43

Advertising