Nokia E62 - Manual (Page 5)

Creating Internet connections
5 Copyright © 2006 Nokia. All rights reserved.
• Max. data speed — Select the limit to apply to the
transfer speed. The speed represents the maximum
speed at which your connection will operate. During
the connection, the operating speed may be less,
depending on network conditions. If you select
Automatic , the data transfer rate is determined by
the network and may be affected by network traffic.
Some service providers may charge more for higher
data rates.
4 After setting up a basic Internet access point for Data
call or High speed data (GSM only) , select Back to save the
settings and exit, or Options
→
Advanced settings to
define the following advanced settings:
• IPv4 settings — Enter the device IP and name server
addresses for IPv4 Internet protocol.
• IPv6 settings — Enter the device IP and name server
addresses for IPv6 Internet protocol.
• Proxy serv. address — Enter the IP address or the
domain name of the proxy server. For example,
domain names are company.com and
organisation.org
• Proxy port number — Enter the proxy server port
number. The port number is related to the protocol.
Common values are 8000 and 8080, but vary with
every proxy server.
Proxy servers are intermediate servers between a
browsing service and its users, which are used by
some service providers. These servers may provide
additional security and speed up access to the
service.
• Use callback — Select Yes if you have a service that
dials back to your device when you establish an
Internet connection.
• Callback type — Select Use server no. or Use other no. ,
according to instructions from your service
provider.
• Callback number — Enter your data call phone
number of your device, which the callback server
uses.
• Use PPP compress. — Select Yes to speed up the data
transfer, if it is supported by the remote PPP server.
• Use login script — Select Yes , if your Internet service
provider requires a login script, or if you want to
automate your login. A login script is a sequence of
instructions that the system follows during the
login process.
• Login script — Enter the login script. This setting is
available only if you have selected Use login script
→
Yes .
• Modem initialisation — Enter a command string for
the connection setup, if required by your service
provider.