Sharp LC-50LE771K - Manual (Page 12)

English - 11 -
Viewing the Connections
Note: When connecting a
device via the YPbPr or Side AV
input, you must use connection
cables to enable connection.
For Side AV input you should
use the supplied cable. See
the illustrations on the left side.
| To enable PC audio, you will
need to use PC/YPBPR AUDIO
CONNECTION WHITE & RED
inputs. | If an external device
is connected via the SCART
socket, the TV will automatically
switch to AV mode.| When
receiving DTV channels (Mpeg4
H.264) or while in Media
Browser mode, output will not
be available via the scart socket.
| When using the wall mounting
kit (available from third party in
the market), we recommend that
you plug all your cables into the
back of the TV before mounting
on the wall. | Insert or remove
the CI module only when the
TV is SWITCHED OFF. You
should refer to the module
instruction manual for details of
the settings. | Each USB input
of your TV supports devices up
to 500mA. Connecting devices
that have current value above
500mA may damage your TV.
| By connecting an HDMI cable
to your TV, you have to use
only a shielded HDMI cable to
guarantee a sufficient immunity
against parasitic frequency
radiation.
Connector Type Cables Device
Scart
Connection
(back)
VGA
Connection
(back)
PC/YPbPr
Audio
Connection
(back)
HDMI
Connection
(back&side)
SPDIF
(Optical Out)
Connection
(back)
Side AV
(Audio/Video)
Connection
(side)
Side AV
Connection Cable
(supplied)
Headphone
Connection
(side)
YPbPr Video
Connection
(back)
USB
Connection
(side)
CI
Connection
(side)
CAM
module
Subw out
Subwoofer
Connection
(back)
LAN Ethernet (LAN)
Connection
(back)
If you want to
connect a device to
the TV, make sure
that both the TV and the
device are turned off before
making any connection. After
the connection is done, you
can turn on the units and use
them.