Philips Power2Charge - Manual (Page 4)

4
ENGLISH
4 Functional overview (fig. A)
PHILIPS
• Lights up when a 5V device is charging (when no
device is connected, the PHILIPS logo will flash).
• Flashes when the device is fully charged.
Foldable power plug
Connects to the wall outlet.
USB port
Connects to 5V DC devices (mobile telephones,
MP3 players, etc.).
5 Operation
Charging devices - preparation
Check the maximum input voltage (V DC) of the
device you wish to connect. For this see the user
manual that came with the device.
Make sure the device does not consume more current
(mA) than 450 mA.
Check what connector tip is required for your device.
See the compatibility sheet for the proper tip for your
device.
Charging 5V devices (fig. B)
Insert the plug of the USB cable into the USB port (3).
Connect the connector tip to the USB cable.
Insert the connector tip into the power supply jack of
the device.
> PHILIPS lights up when a device is charging.
> PHILIPS will flash when the device is fully charged.
Disconnect the device from the USB adapter.
6 Technical specifications
• Rated input: 110V - 240V AC (60/50Hz)
• Rated output: 5.6V DC, max. 450 mA
• Operating temperature: 0ºC - 45ºC
• Size: 70.3 x 55.5 x 35.5 mm (h x w x d)
• Weight: 70 g
7 Troubleshooting
Problem
– Possible cause
• Solution
USB adapter does not charge connected device
– Voltage of device does not correspond with that of USB
adapter.
• Refer to the user manual that came with the device.
– Improper connection between device and USB adapter.
• Make sure that the USB cable is properly inserted into
the device and the USB adapter.
– Damaged USB cable or connector tip.
• Replace USB cable and/or connector tip.
– Wrong connector tip used.
• Check connector tip and replace if necessary.
– Non supplied USB cable / connector tip used.
• Replace with supplied USB cable/connector tip.
– Problems with electrical circuit of USB adapter.
• Take the USB adapter to your local distributor.
4
3
2
1
3
2
1
3
2
1
SCM4480 12-09-2007 12:39 Pagina 4