Burley PRE-2004 - Manual (Page 7)

7
Burley Walk ‘n Roller Manual; models 2003 and earlier
V. Mount Wheel Pivot Assembly
Parts Included for the Pivot wheel Assembly Attachment:
(1) 1/4 x 2” hex bolt
(1) Pivot Wheel Assembly
(3) 1/4” locking nuts (3) 1/4 x 1” hex bolts
(3) 5/8” washers
Temporary Hitch Removal
Before installing the Wheel Pivot Assembly, the hitch has to be removed from the
end of the tongue. Loosen and remove the securing bolt, #1 in the drawing on the
next page.
• As you remove the bolt, notice how it secures the hitch though the hitch
connector (#2) and the safety strap (#4).
• Save the hitch and the d-ring (#3) for reinstallation. The locking nut (#5) and the
bolt (#1) can be discarded. A longer bolt is provided for the next step.
Always check the handle attachment before using. Be sure
that handle is properly installed with buttons protruding in the
locked position. Failure to do this could lead to loosening of
handle, loss of control, and serious injury.
3
1
2
4
5