Bush Hog 3860 QT - Manual (Page 16)

REMOTE HOSES SUPPORT
After installing loader onto tractor, raise the loader to
full height, stop engine, lock brakes, and remove
key. Then gather remote hoses and install nylon tie
through hose support hole located in right hand
loader subframe. Secure hoses as shown. This will
allow remote hoses to be supported by loader frame
instead of loader steel tubing. Refer to Figure 5.
CAUTION
DO NOT STAND, WALK OR WORK UNDER
A RAISED LOADER OR ATTACHMENT
UNLESS IT IS SECURELY BLOCKED OR
HELD IN POSITION. ACCIDENTAL MOVE-
MENT OF A CONTROL LEVER/LEVERS OR
LEAKS IN THE HYDRAULIC SYSTEM
COULD CAUSE THE LOADER TO DROP,
OR ATTACHMENT TO DUMP, CAUSING
SEVERE INJURY.
3
1
4
5
2
THIRD CYLINDER TUBE KIT
(OPTIONAL)
Install two steel tubes to inside of right hand loader
boom. Then connect the two hoses and fittings to
the front of the steel tubes. Refer to Figure 6 for fur-
ther installation instructions.
NOTE: Hydraulic hoses from third cylinder steel
tubes to tractor rear remotes are not supplied in
this kit.
Figure 6
(1) Nylon tie
(2) Snap pin (note location)
(3) Remote hoses
(4) Subframe (right-hand shown)
(5) Right hand support hole located in subframe
Figure 5
(1) Steel tubes.
(2) Existing tube clamp, 2 places.
(3) New tube clamp, secure using 3/8" nylon locknut.
(4) Fitting, 90° JICM 3/4" x JICF 3/4", install one on
each tube.
(5) Hoses 3/8" x 80", installed to fitting on steel
tubes.
(6) Install hose protector over hoses. Secure each
end using nylon ties.
(7) Male and female quick couplers, supplied with
attachment. Connect one to each hose.
14