Brother MFC 4300 - Manual (Page 80)

8 - 4 R E M O T E F A X O P T I O N S
Remote Commands
Follow the commands below to access features remotely. When you call the
MFC and enter your Remote Retrieval Access Code (1 5 9 ), the system will
signal you with two short beeps to enter a remote command.
Remote Commands Operation Details
95 Changing Fax
Forwarding / Paging
setting
1 OFF If you hear one long beep, the change is
accepted. If you hear three short beeps, you
cannot change it because the conditions have not
been met (Example: registering paging number).
You can register your fax forwarding number by
using 4. FAX FWD NO (see p. 8-1). Once you
have registered the number, the MFC will
change automatically to FAXFWD:ON mode.
Then retrieve a Memory Status List by entering
961 (see p. 8-5) to make sure that the Fax
Forwarding number you registered is correct in
the List.
2 Fax Forwarding
3 Paging
4 FAX FWD No.
6 Fax Storage ON
7 Fax Storage OFF
You can set FAX STORAGE to ON or OFF.
96 Retrieve a fax
1 Memory Status List Enter the number of a remote fax machine to
receive the Memory Status List or stored fax
message(s). (See p. 8-5)
2 Retrieve all faxes
3 Erase fax from the
memory
If you hear one long beep, you can erase fax
message(s) from the memory.
97 Check the Receiving
Status
1 FAX You can check whether your MFC has received
any faxes. If yes, you will hear one long beep. If
no, you will hear three short beeps.
98 Change Receive
Mode
1 TAD If you hear one long beep, you can change the
Receive Mode. If you hear three short beeps, you
cannot change it.
2 FAX/TEL
3 FAX
90 Exit After a long beep, you can exit remote access.