Brother DCP-385C User Manual
Page 78
72
No Paper Fed
The machine is out of paper or
paper is not properly loaded in
the paper tray.
Do one of the following:
Refill the paper in the paper tray, and
then press Mono Start or Color Start.
Remove the paper and load it again
and then press Mono Start or
Color Start.
The Jam Clear Cover is not
closed properly.
Check that the Jam Clear Cover is closed.
(See Printer jam or paper jam on page 73.)
The paper is jammed in the
machine.
See Printer jam or paper jam on page 73.
Out of Memory
The machine's memory is full.
Copy operation in progress
Press Stop/Exit and wait until the other
operations in progress finish and then try
again.
The memory card or USB Flash
memory drive you are using does
not have enough free space to
scan the documents.
Delete unused files from your memory card
or USB Flash memory drive to make some
free space and then try again.
Paper Jam
Paper is jammed in the machine. Remove the jammed paper by following
the steps in Printer jam or paper jam
on page 73.
Make sure the paper length guide is
adjusted to the correct paper side.
Unable to CleanXX
Unable to Init. XX
Unable to Print XX
Unable to Scan XX
The machine has a mechanical
problem.
–OR–
A foreign object such as a clip or
ripped paper is in the machine.
Open the scanner cover and look on the
left, middle and right hand side under the
covers for foreign objects and paper
scraps. If the error message continues,
disconnect the machine from the power for
several minutes, then reconnect it.
Unusable Device
Disconnect device
from front connector
& turn machine off &
then on
A broken device has been
connected to the USB direct
interface.
Unplug the device from the USB direct
interface, then press On/Off to turn the
machine off and then on again.
Unusable Device
Please Disconnect USB
Device.
A USB device or USB Flash
memory drive that is not
supported has been connected
to the USB direct interface.
For more information, visit us at
Unplug the device from the USB direct
interface.
Wrong Paper Size
Paper is not the correct size.
Check that the machine's "Paper Size"
setting matches the size of paper in the
tray. (See Paper Size on page 21.)
Error Message
Cause
Action