Philips DVD740VR98 - Manual (Page 40)

POWER
MARKER
SEARCH MODE DISPLAY SLOW ZOOM
OUTPUT SELECT
3
4 5 6
7 8 9
SPEED
TIMER SET
0 +10
2 1
VCR DVD
CLEAR
REPEAT
SETUP
TITLE RETURN MODE
CHANNEL/SKIP
A-B
AUDIO ANGLE SUBTITLE
REC/OTR REPEAT
DISC
MENU OK
PAUSE
REW FF
PLAY STOP
VCR/TV
MEMORY
STATUS/EXIT TIME SEARCH
• The MEMORY button does not
function if REPEAT PLAY is ON.
Details are on page 39.
• To erase a real-time tape counter
memory, press MEMORY until the
M disappears from the screen.
• You may only set the real-time tape
counter to zero at one location at a
time. Setting the real-time tape
counter to zero at a second location
will erase the previous zero setting.
• If you remove the tape, the counter
will reset to zero at the point at
which you last stopped playback
whenever you reinsert the tape.
Helpful Hints
STOP 1:08PM
TV STEREO CH10
SLP 1 : 23 : 45 HIFI
Follow the steps below to reset the real-time tape counter to
zero at a tape location you want to refer to later.
● Before you begin, place the DVD/VCR in VCR mode.
Press OUTPUT SELECT so the green VIDEO light appears on the
front of the DVD/VCR.
1 Press VCR, then play, fast forward, or rewind a tape
to the location that you would like to refer to later.
Press STOP C (p) to stop the tape.
2 Press DISPLAY/STATUS/EXIT to see the status
display.
3 While the status display is on the screen, press
CLEAR to reset the real-time tape counter to zero.
STOP 1:08 PM
TV STEREO CH10
SLP 0 : 00 : 00 HIFI
4 While the real-time tape counter is on the screen,
press MEMORY so M appears beside the counter.
STOP 1:08 PM
TV STEREO CH10
SLP M 0 : 00 : 00 HIFI
5 To go to a tape location where the real-time tape
counter was reset to zero, press REW h (s) or
FF g (B) when playback is stopped.
When the tape reaches the point at which the counter was
set to zero, the tape will stop. Press PLAY B (o) to
watch the tape.
40 Real-Time Tape Counter Memory
2
3
4
5
1
VCR
DVD740VR 4/12/02 12:09 PM Page 40