Gradall G6-42P (91404003_Before 0160004017) Operation Manual - Manual (Page 23)

Form No. 20027 • G6-42P Owner/Operator Manual
Precautions
• Avoid parking on slopes or near an excavation.
• Park on level ground and block wheels.
• Avoid parking on roads or highways. If it cannot be avoided, be sure to
display warning flags during day and flares or flashing lights at night.
• Position boom-head or attachment on ground; never leave machine with
boom in air.
• If parking on a slope cannot be avoided, position the handler at a right angle
across the slope, straighten rear wheels and block all wheels.
Parking procedure
1. Using service brake, stop the handler in an appropriate parking area.
2. Move parking brake switch to “On”.
3. Shift forward/reverse lever to “Neutral”.
4. Position boom-head or attachment on ground.
5. Allow engine to cool at idle speed for 3 to 5 minutes, stop engine and remove
ignition key.
6. Block wheels as an extra precaution against rolling.
7. Fill fuel tank to minimize condensation.
8. Lock cab and install protective covers, if so-equipped.
9. Disconnect batteries if unit is in an area where tampering is a risk.
• It is imperative that the operator practice maneuvering the handler in a
safe, open area to become thoroughly familiar with steering response
and clearance required for tail swing and load when turning.
WARNING !
Be alert for any increase in effort
needed to steer. If any difference
is noted, notify maintenance
personnel immediately. If power
assist feature should fail for any
reason, IT WOULD BECOME VERY
DIFFICULT TO STEER. For this
reason it is extremely important
that you NEVER TURN ENGINE OFF
WHILE TRAVELING.
If power steering fails, stop as
soon as possible. Do not drive
handler until problem has been
corrected.
PARKING THE HANDLER 8.0
STEERING SYSTEM 9.0