J.P. Instruments EDM 760 Instrument Installation Manual - Manual

Installation manual for the EDM-760 Twin STC SA00729SE
Report No. 760
Temperature indicating system with Fuel Flow Date 7/20/99 Rev NC
Page 1 of 19
THE OWNER OF THE EDM-760 MUST KEEP THIS MANUAL
TABLE OF CONTENTS
Page
1. INSTALLING THE INDICATOR 2
2. EXHAUST GAS TEMPERATURE PROBE 2
3. TURBINE INLET TEMPERATURE PROBE 2
4. USING ORIGINAL TIT PROBE 2
5. CYLINDER HEAD TEMPERATURE PROBE 2
6. SPARK PLUG GASKET CHT PROBE 3
7. INDUCTION AIR/CARBURETOR TEMPERATURE 3
8. OIL TEMPERATURE PROBE 3
9. OUTSIDE AIR TEMPERATURE PROBE 3
10. FUEL FLOW OPTION 3
11. DATA PORT 3
12. WIRING 3
13. EGT AND CHT PROBE WIRING MARKINGS 4
14. ROUTING THE WIRING HARNESS 4
15. INDICATOR INSTALLATION & RECORD 4
16. DESCRIPTION OF INSTRUMENT 5
17. INSTRUMENT OPERATION 6
18. OPERATION 6
19. SPECIFICATIONS AND LIMITATIONS 6
20. COMPONENT PARTS LIST FOR EGT/ TIT PROBE 7
21. COMPONENT PARTS LIST FOR CHT PROBE 7
22. COMPONENT PARTS LIST FOR OIL PROBE 7
23. COMPONENT PARTS LIST FOR OAT PROBE 7
24. COMPONENT PARTS LIST FOR IAT PROBE 7
25. COMPONENT PARTS LIST FOR TWIN ENGINE EGT/CHT 7
26. WEIGHT AND BALANCE DATA 7
27. CHANGING PROGRAMMED LIMITS 8
28. TROUBLE-SHOOTING 9
FIG-1 INSTRUMENT BEZEL TEMPLATE (DWG. 760124) 10
FIG-2 EGT/CHT/TIT PROBE PLACEMENT 11
FIG-3 EGT PROBE INSTALLATION 12
FIG-4 OIL PROBE INSTALLATION FOR LYCOMING 13
FIG-5 OIL PROBE INSTALLATION FOR CONTINENTAL 14
FIG-6 DRAWING 5057 WIRE PREPARATION 15
FIG-7 WIRING LIST TWIN EDM-760, DRAWING 760701 16
FIG-8 WIRING THERMOCOUPLE DIAGRAM DRAWING 760202 17
Fig-9 WIRING FUEL FLOW DIAGRAM 760744 18
INSTRUCTIONS FOR CONTINUED AIRWORTHINESS (ICA) 19
APPENDIX – A, FUEL FLOW TRANSDUCER INSTALLATION
J.P.INSTRUMENTS
PO BOX 7033
HUNTINGTON BEACH CA 92615
Last printed 7/15/04