JB Conversions 16-1204 HD Standard Length SYE Kit for the NP241 - Manual (Page 15)

15
28) Apply silicone RTV to the back of the new bearing housing. Install
the bearing housing onto the rear case half using the original 10mm
bolts (Fig.29)
FIG: 29
29) Install the yoke followed by the rubber star washer as shown in
Fig.30a. Torque the nut to 180 lb-ft. (Fig.30b).
FIG: 30a FIG: 30b
30) Install the stock speed sensor to complete the installation.