2GIG TS1 - Touch Screen Wireless Keypad - Manual (Page 3)

©2013 2GIG Technologies Inc. All Rights Reserved. 3
LEARNING/PAIRING THE KEYPAD WITH THE
CONTROL PANEL
1 Make sure that the Control Panel has power using the supplied AC
adapter and confirm that the adapter is connected.
WARNING: A Control Panel without the 900 MHz Transceiver
installed cannot communicate with the 2GIG‐TS1.
2 Make sure that the 2GIG‐TS1 has power from the supplied AC
transformer. Connect the AC adapter to the 2GIG‐TS1. Confirm that
the wires are connected using the correct polarity.
3 As the 2GIG‐TS1 powers up, the following message is visible on the
display.
4 From the Control Panel’s Installer Toolbox, select System
Configuration.
5 Select the Go To button.
6 To go to question 4, enter 04.
7 Select the RF Keypad number to assign to the 2GIG‐TS1. Use the →
arrow to select the RF Keypad number (1‐4). After selecting the RF
Keypad number, press the ↓ arrow to start configuring the specific
parameters for the RF Keypad.
8 Press the → arrow or press the number 1 on the keypad toggle the
se ng on the first ques on to “used”. Press the ↓ arrow to con nue
configuring options.
9 Set the RF Keypad Equipment Code to 1059 by pressing the → arrow
until “(1059) 2GIG‐TS1 wireless touchscreen keypad” appears. Press
the ↓ arrow to advance to the next op on.
10 Learn the 2GIG‐TS1 into the Control Panel. A er pressing the ↓
arrow in the previous step, the Learn button appears.
INITIATING THE PAIRING PROCESS
Initiate the pairing process at the Control Panel by pressing the Learn
button.