Apple WaveBurner 1.6 - Manual (Page 42)

3 In the Normalize dialog, set a target level lower than the maximum peak level (0 dB) if
appropriate.
4 If appropriate—and several regions are selected—activate the Normalize Each Region
Individually checkbox to normalize each region individually.
Note: Normalizing can cause a change in the relative volumes between regions. You can
maintain the relative volumes of selected regions by ensuring that this checkbox is
disabled.
Checking a Region for Clipping
You can check regions for clipping at any time. The Mix lane waveform indicates clipping
by turning red, providing an at-a-glance indicator that a problem exists.
To check regions for clipping
1 Select the regions in either the Wave View area or the Regions list.
2 Choose Region > Check Region for Clipping.
After completing the process, a detailed log displays the results of the clipping analysis.
42 Chapter 3 Working with Regions