Apple Xserve (Early 2008) DIY Procedure for Rear ID Tab User Manual

Page 24

Advertising
background image

Xserve (Late 2006/Early 2008) Rear ID Tab Replacement Instructions

24

Carefully seat the heat sink over the processor, aligning the four screws with the holes in the

11.

logic board.

Tighten the four captive Phillips mounting screws for the heat sink in the order indicated

12.

below. Do not over-tighten the screws. If you have a torque driver, tighten the screws to 8
inch-pounds; otherwise, try to tighten the screws with equal pressure.

Replacing the Backplane-to-Logic Board I/O Cable

Fold the replacement cable to a 90-degree angle along its creases.

1.

Advertising
See also other documents in the category Apple Software: